CAN BUS Training stand Training board – simulator

Početna/Trgovina/Strukovne škole/Automehatronika/CAN BUS Training stand Training board – simulator

CAN BUS Training stand Training board – simulator

Fully functional CAN – BUS network system is installed in a mobile aluminum frame. This training board-simulator is specially designed to help technical students understand better the system`s construction.

           The educational training board is based on Mercedes – Benz components. The stand is equipped with a functional CAN GATEWAY 2.0 system.

           Training board-simulator is a great educational tool that allows students to learn the structure of CAN gateway system, study its components, and perform various measurements, tests and other diagnostic procedures.



Technical specifications and functions
·         Training board is equipped with a CAN gateway 2.0  network system that includes:


–       Dashboard ;

–       Engine ECU;

–       Smart Key, ignition module, lock module;

–       SRS Airbag ECU ;

–       Central  CAN Gateway module (ECU)

–       Front and rear doors control modules;

–       Front and rear windows lifting motors

–       Front and rear windows lifting switches


·         All the components are connected to the internal network. The network is shown as a diagram for better understanding;

·         The modules communication can be connected or disconnected by banana plug jumpers. There can be connected or disconnected Low and High speed CAN lines on the stand;

·         CAN getaway diagram with built in banana plug jumpers for measurements and simulation of system malfunctions;

·         Ability to simulate more than 10 system faults;

·         The window lifting motors are active and controlled by switches and doors control modules

through CAN gateway network of the car;


Diagnostic and measurement


·         System’s parameters are measured by connecting to the banana connector

·         Ability to measure electrical signal parameters of system component


Control unit diagnosis


·         Diagnosis through OBD 16 – pin diagnostic connector;

·         Diagnose all presented control units in the CAN bus network by using an automatic search (depending on the diagnostic tool possibilities);

·         Diagnose of each control module separately;

·         Electronic control unit (ECU) identification;

·         Reading/erasing fault codes;

·         Displaying the operating system parameters (live data);

·         Activating the actuators (Depends on the control unit);

·         Control unit encoding/configuration (Depends on the control unit);



·         The stand has a closed structure – internal wiring is not visible

·         Power supply: 12V from the battery (not included as standard accessory)

·         Dimensions approx.: (HxLxW) 1820x1360x500mm

·         Nett weight approx.: 60 Kg

·         Made in Lithuania

·         CE certificate


Optional accessories


·         12 V battery

·         220/12 V Power supply unit

·         Automotive oscilloscope

·         CAN Network analyzer

·         OBD diagnostic scan tool




Go to Top